Reply to thread

Ok guys here's my problem..

I have a stormtrooper bucket that is a very good replica except from one thing, the face from a front view seems to be slightly to wide.

How do I go about making a cast/mould of this bucket without damaging it. I would prefer to make a cast/mould then work on that rather than attempting a repair job as I have no knowledge of casting/moulding.

Any help at all would be greatly appreciated.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top