Reply to thread

Message

Couple things about the EE3 and sidearm.

EE3: Dont 'screw' a pivot in for holding the sling! Drill it out extra big, fill it with glue/epoxy and then screw into that, and let it cure. Youll shatter the plastic by screwing it in tight, like wood.

Sidearm: I have been unable to figure out if the grip should be hollow, or filled. Most pics of peoples guns and mojos gun have it filled, however the original is hollow (as I make it). It may need to be filled with bondo.

Good luck everyone with their EE3s and sidearms.

[QUOTE="Stormrider, post: 334547, member: 2155"] Couple things about the EE3 and sidearm. EE3: Dont 'screw' a pivot in for holding the sling! Drill it out extra big, fill it with glue/epoxy and then screw into that, and let it cure. Youll shatter the plastic by screwing it in tight, like wood. Sidearm: I have been unable to figure out if the grip should be hollow, or filled. Most pics of peoples guns and mojos gun have it filled, however the original is hollow (as I make it). It may need to be filled with bondo. Good luck everyone with their EE3s and sidearms. [/QUOTE]

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification