Reply to thread

Yes, you need to drill them out so they aren’t “attached” to the knees, but rather run through them.  I used a drill bit initially, then Dremeled the rest out for a tight fit.


Some artists supply resin blocks that sit behind the armor, and the knee launchers fasten to this.  You might be able to fab something up too, but the resin ones fit like a glove!  I just did mine!


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top