Reply to thread

Message

"This Bondo brand Fiberglass Resin consists of only a one-part solution and has the hardner already mixed in."

PLEASE READ THE DIRECTIONS ON THE CAN FIRST!! No it dosn't!! It comes with the hardener seperatly and YOU have to mix it in your self. It is NOT already mixed in, repeat NOT already mixed. You'll have a big mess if you use the resin directly out of the can without using the hardner as it will never cure.
I don't want to see you get into trouble doing this.
Also it DOES heat up a little when curing, that is the normal chemical reaction that happens when the curing process happens when you mix the resin with the hardener. If your fiber glass resin isn't too thick, 1/4" or more, it won't heat up enough to do any "possible" damage. I lined my PVC ANH trooper helmet using the same resin fg stuff you have in your pic and I got it a 1/2" thick puddle of resin in one part of the helmet and man was it HOT!!!!
Lynn

<blockquote data-quote="Migrate from As You Wish" data-source="post: 1523">&quot;This Bondo brand Fiberglass Resin consists of only a one-part solution and has the hardner already mixed in.&quot;PLEASE READ THE DIRECTIONS ON THE CAN FIRST!! No it dosn&#039;t!! It comes with the hardener seperatly and YOU have to mix it in your self.&nbsp; It is NOT already mixed in, repeat NOT already mixed. You&#039;ll have a big mess if you use the resin directly out of the can without using the hardner as it will never cure.I don&#039;t want to see you get into trouble doing this.Also it DOES heat up a little when curing, that is the normal chemical reaction that happens when the curing process happens when you mix the resin with the hardener. If your fiber glass resin isn&#039;t too thick, 1/4&quot; or more, it won&#039;t heat up enough to do any &quot;possible&quot; damage.&nbsp; I lined my PVC ANH trooper helmet using the same resin fg stuff you have in your pic and I got it a 1/2&quot; thick puddle of resin in one part of the helmet and man was it HOT!!!! Lynn</blockquote>

[QUOTE="Migrate from As You Wish, post: 1523"] "This Bondo brand Fiberglass Resin consists of only a one-part solution and has the hardner already mixed in." PLEASE READ THE DIRECTIONS ON THE CAN FIRST!! No it dosn't!! It comes with the hardener seperatly and YOU have to mix it in your self. It is NOT already mixed in, repeat NOT already mixed. You'll have a big mess if you use the resin directly out of the can without using the hardner as it will never cure. I don't want to see you get into trouble doing this. Also it DOES heat up a little when curing, that is the normal chemical reaction that happens when the curing process happens when you mix the resin with the hardener. If your fiber glass resin isn't too thick, 1/4" or more, it won't heat up enough to do any "possible" damage. I lined my PVC ANH trooper helmet using the same resin fg stuff you have in your pic and I got it a 1/2" thick puddle of resin in one part of the helmet and man was it HOT!!!! Lynn [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification