Reply to thread

If you have a dremel, you should be able to find some 1/4" thick bar stock at HD or Lowes, and cut it to fit.  Also, onlinemetals.com sells small pieces of metals.  You could even get it cut to the correct length and then cut out the shape with your dremel tool.


Just my 2¢.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top