Reply to thread

What is the simplest method to replace the RF? My one (the original plastic thing on the DP 97) is still intact, but I look to the future and this part seems to be very fragile.

I never found any good aluminum rod in 2 years of looking!

Maybe should I  recast it out of resin before it’s too late but I must admit though that working with such material is my weak point. So can someone PM me to give me some advices how to proceed? Thanks!


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top