Reply to thread

Update, in case someone else find themselves in this situation. I hit the high parts ( area I can feel with finger) with 2000 sand paper. Then did the whole helmet at 3000 sand pad. I then using a polish compound and lots of elbow grease and that did the trick.


Hard to tell from photo but close up is before and the long shot is after.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top