Reply to thread

You want black and brown pastel chalks applied with a brush and sealed with clear matte spray. Thats a more realistic carbon and grime look. Its what i've use on my helmets and armor. Take a x-acto knife(carefully) and scrape the chalk into a dust pile and dip dry brush into it and then apply to helmet in layers. If it does not look right just wipe with damp towel and start over.

Have fun with it and Good luck!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top