Reply to thread

The lower cheek on my helmet curves out ward a bit, this disallows the t-visor to sit flush with the helmet. I was thinking of heating it and bending it back inwards. Question is what would be the best way to bend it back and have it stay?


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top