Reply to thread

I used Pistol Solid's Condor padding... Very modular. Put velcro hook inside the helmet and place the padding wherever you need it. I use one thick piece of craft foam for the back (Where the circuit board bulge is. My head pushes against that)

 That inflatable foot ball helmet stuff would be a good idea, too.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top