Reply to thread

Heres the pics of the V1 (dirty) kit installed.  The V2 is in silicone.  The v3 is on my bench (RIddell)


I decided to go with a leather look on the rubber.  Darker skin with lighter center foam.  It gave it a 'realistic' look right out of the mold.  The top pictures are flat black as they exit the mold.  The bottom is with a 1 minute rub and buff on it.


The top center piece may need to be thinner,  and a forehead piece needs to be made.  Maybe just an extra leather piece,  to cut and use all over.


They look better in a painted gray or black interior,  but I wanted it to stand out exactly what you were looking at/getting:)


enjoy


Feedback is very welcome.



This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top