Reply to thread

While we are waiting....(elevator music) I figured I would upload my EE-3 build. This is a 3D printed model from Woodtech armory. I worked on this for so long. So many lines and corrections. Had to re-stain the barrel after affixing the greeblies incorrectly the first time. Battled with it for a while. Got it to where I wanted it and I'm actually pretty happy with it. Still need to put the correct scope hardware down on the bottom and also get a sling and swivels but it's on its way. I far surpassed my expectation for a 3d print. Very happy with the stock stain. The Tamiya modelling rub really brought the rifle to life. It made it look like cold steel. That's also plastic. Still need to give it the famous "67" or "69" signature but the majority of the work is done. Threw it up on the wall mount for now. Will get back to it for the finishing touches. Let me know what you think.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top