Reply to thread

Bright silver/chome aluminum layer complete. That was tough. I remember trying to do this last time without the exact scale needed to make shapes match. Having the stencil for the base layer is paramount. At a minimum, I can't say that enough. It truly sets the tone for the rear panels which are the toughest part of the helmet in my opinion. On to the next layer! [ATTACH=full]223358[/ATTACH]


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top