Reply to thread

I used acrylic and heated it over the electric range until bendy. If you use the small elements then you can keep your visor curve. Then I used a standard paintcan for housepaint and put the visor on it, pressing with oven mitts.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top