Reply to thread

I have the epoxy glue and the putty. I put my visor in the oven to curve it better. I have done all my research on this site,so now I will ask you all. How in the hell do I curve the middle of the visor, and how long does it stay in the oven? I put at 350 the middle was hard to bend and was afraid to brake it.I then tried to install the visor. The first and second attempt was the same outcome, the middle of the visor kept coming off the mandibles. But everything held,but the middle part didn't! Does the visor need to be trimmed,because it has alot of extra lens that you can cut. Info,secrets I just want to finish my helmet for the show in Plano, JB is gonna be Saturday @ 2:00. So my first helmet can be signed and I can start on my other one.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top