Reply to thread

A little Dremel...a little drill press...a little sandpaper...a lot of handcarving!!!

 

The little slots are hand carved as well as the depressions on the edges of the ball.  Still a lot of work to do.

 

I plan on just doing one of these and then making a mold of it because I can't really stomach the thought of carving another one!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top