Reply to thread

Hey FP. I look up to you as a great builder around here, and it is a huge honor for me to know you like them.

 

As for the mold, yeah, it is a two part as seen in the pic below, with a separate cap section for the front piece. The body then has to be hollowed. Originally I had both as one, but JB suggested I make them two when I took the molds to him. So we made some last minute modifications.

 

Well, my solution was this: You bring your amazing gauntlets out of retirement to offer folks cold-cast versions.:) At this time, I have come to like the expediency of gel-coat, fiberglass, and quick setting casting resin.:thumbsup: The cold cast is a pain in the...rear, and I have yet to make a successful pull. But all of my molds are two piece, so there are seam lines in all of them.

 

In all genuine honesty, if you could bring yours out of retirement, I could sleep peacefully again!:lol:

 

I'll shoot you that PM.

 

Thanks,

Cruzer


[ATTACH=full]10325[/ATTACH]


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top