Reply to thread

Message

Not much to report on this. I have added back some physical damage in a few places where the GM casting was too rough to preserve them.
I am still waiting on the screws for my visor. Once I have those I can move forward on the GMH.

In the meantime, I have been working on another helmet I found just sort of hanging out in my closest. And I just so happened to find some aluminum ears in a desk drawer. So I thought; Why not put them together?
[ATTACH]29149[/ATTACH]
I am taking this FP MR helmet to finish in ESB style and I hope to start painting it very soon. I will start another thread on that if I dont screw it up...

[QUOTE="Keegan, post: 324367, member: 1160"] Not much to report on this. I have added back some physical damage in a few places where the GM casting was too rough to preserve them. I am still waiting on the screws for my visor. Once I have those I can move forward on the GMH. In the meantime, I have been working on another helmet I found just sort of hanging out in my closest. And I just so happened to find some aluminum ears in a desk drawer. So I thought; Why not put them together? [ATTACH]29149.vB[/ATTACH] I am taking this FP MR helmet to finish in ESB style and I hope to start painting it very soon. I will start another thread on that if I dont screw it up... [/QUOTE]

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification