Reply to thread

Use a high watt spot light or heat lamp on the glass to help it cure. I used to use it to help some of my molds cure faster and help to reduce tackyness. Sometimes, I would tent a piece of tin foil over the spot light to contain the heat.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top