Reply to thread

Message

Hi, I'm fairly new here and have been improving upon an ESB costume I made for halloween. I recently got a girth belt, having not even known of such a thing before now, and have stained it.

[ATTACH]57269[/ATTACH]

I'm ready to make the straps for the back, and would like to verify how to do that. I was planning on black nylon webbing/strap 1" wide, which is what fits the buckles.

My real question is about the ends of the straps. Are both ends buckled? Or is one end sewn, the other buckled? Do other people have grommets in the webbing for the buckle prong? Or is just poking holes in it ok? Thanks for any advice.

[QUOTE="Gregory, post: 423540, member: 8301"] Hi, I'm fairly new here and have been improving upon an ESB costume I made for halloween. I recently got a girth belt, having not even known of such a thing before now, and have stained it. [ATTACH]57269.vB[/ATTACH] I'm ready to make the straps for the back, and would like to verify how to do that. I was planning on black nylon webbing/strap 1" wide, which is what fits the buckles. My real question is about the ends of the straps. Are both ends buckled? Or is one end sewn, the other buckled? Do other people have grommets in the webbing for the buckle prong? Or is just poking holes in it ok? Thanks for any advice. [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification