Reply to thread

Sorry if I seem to keep up this thread, but I was curious as to start somewhere, and possibly make my own RF. I was thinking about getting some cheap metal, or possible aluminum, and getting the right thinckness, lenght ect, at the local Lowes hardware store, or Home Depot. I was wondering if there was a template for the stalk at least, if anyone can help me with it. Thank you

 

-tubachris


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top