Reply to thread

Helmet joins sealed. I actually used blu tack and then covered it in superglue to harden it. It's a technique I have used numerous times in the past for minature modeling. The helmet after all is only a master that is to be molded and using the sand able spray paint will just add more solidity to the helmet


[ATTACH]63311[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top