Reply to thread

[ATTACH]63306[/ATTACH][ATTACH]63305[/ATTACH][ATTACH]63304[/ATTACH][ATTACH]63307[/ATTACH]


Getting closer and closer. Just have to fill in the join points between the main helmet and the dome then it's on to the spraying stage with the sand able paint which should hopefully fix any imperfections in the dome and fill in the small joins in the main helmet base


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top