Reply to thread

Photo updates

this is the dome being completed with .5mm plastic then covered in Jesmonite the a butt load of sanding. Annoyingly I can't get the top of the dome totally nice and even so more work is needed.

Then I have the first ear. I have made it possible to install a micro switch with lever to activate the eventual lighting system of the range finder


[ATTACH=full]63264[/ATTACH]


[ATTACH=full]63265[/ATTACH]


[ATTACH=full]63266[/ATTACH]


[ATTACH=full]63267[/ATTACH]


[ATTACH=full]63268[/ATTACH]


[ATTACH=full]63269[/ATTACH]


[ATTACH=full]63270[/ATTACH]


[ATTACH=full]63271[/ATTACH]


[ATTACH=full]63272[/ATTACH]


[ATTACH=full]63273[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top