Reply to thread

Yes, either talc or polyfiber will work fine. Just keep adding it little by little till you get a peanut butter like consistency and use a popsicle stick or brush to trow it into the details that you feel will not laminate well.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top