Reply to thread

It's hard to say without seeing your helmet.  At least sand the imperfections out.  I use 60 grit for removing paint, 150 grit for smoothing out the scuffs the 60 grit left, and then 320 grit to finish it up and give it a nice feel.  If it's not that bad, you can probably just use some 150 & 320 on it.  :)


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top