Reply to thread

since no one else here can take the time to answer this, yes its a good idea to sand the primer down, depending on the finish, anywhere from 400 and up is good, i usually start at 600 grit wet/dry sandpaper, wet it, and then sand it or you can go higher up in grit. Then proceed and paint it.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top