Reply to thread

Bobamaker gauntlets have an overlaping calmshell set up. You will not be able to trim the bottom shell. You would need to trim from the top shell. Unfortunately, after you trim, it likely will not line up perfectly the way it does now based on the curve of it. But I can be done cautiously.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top