Reply to thread

I was doing some cleaning of my little work shop yesterday when I realized the "Swifer" (sp?) I was using had the ridges and looks "clean", plus it metal so lots of possibilities there, bnut alas the diameter is like 1/2 inch so.....:angry

I may use it for something else though. That's the joy of doing a custom  :D


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top