Reply to thread

I just printed out the WOF templates for the gauntlets and was looking for advise. What is the best material to use: cardboard, sintra, metal?

I am a ceramic sculptor, and I can be patient, so saying that, what is the most ideal for look, feel, etc...I know opinions may differ, and I openly accept all of them.  I was thinking sintra, then fill it with bondo to get a perfect finish.  But if I use sintra, do I have to modify the templates, or can you heat and bend them at the fold points?  I have made trashcan armor, and have used a heatgun quite a bit, just never worked with sintra.  Any advise would be greatly appreciated.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top