Reply to thread

I used the ESB templates because that is my ultimate goal. I think I will make a few before I really go for it, so this one will be a custom mando.  The material is just over 2mm so the thickness isnt that bad. I am considering using two layers glued together, but?  That will certainly make the dents easier to dremmel out, versus heating and melting it just right. I gave the pieces a good sanding and they look much better than the first pics I showed.  I am really surprised at how it is coming along. I would have never guessed! Thats why I ignored the threads for so long. Well I just got off work and will take some more pics tomorrow...


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top