Reply to thread

Lynn,

Unfortunately I didn't take any progress pics.What I did for the harness is I ran a pvc pipe through the jet pack to attach the thrusters.I looped 1"nylon straps around the pipe and sewed them.I then ran the straps up and behind a second piece of pvc pipe that I epoxied into the pack.The straps then come out of the pack through small holes cut into the plastic.I then attached seat belt ends ,out of a Mustang(I installed racing harnesses years ago) ,to the ends of the straps.I just looped it through and sewed it .The seat belt ends work PERFECT!They are small and very easy to attach.I adjusted the straps so that the seat belt ends just barely stick out of the pack.I made my harness so that I can attach the pack then pull it tight and attach it to itself.After wearing it for several hours on Halloween night,It is the part of the costume I am happiest with.

Hope this helps,


Ron

TK/BH-1889


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top