Reply to thread

Thanks man! I'm no master at this stuff or anything but I might be able to help :) What servo are you using? Brand name, model number if you have it, voltage etc. You're doing a remote hookup correct? So you got a little button fob with the board right? Have you done any soldering on the 9 pins of the board yet? One big thing is it works a whole lot better if the switches/remote lines don't touch at all. Post here or feel free to shoot me a pm and we'll try to get it goin!


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top