Reply to thread

GCN, Prymer...Thanks for the compliments!  Well I'm the first to admit that it's not perfect.  It is a pretty sharp cut.  Perfect is pretty hard to achieve, but I can tell you that these are perfect for an MLC or a scratchbuilt project.


Still two left!!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top