Reply to thread

Message

What, the copper part? Nah, we stared at this picture a few weeks ago. The base copper still looks like plating to me. If it was plastic I'd expect the base copper color to have as much peeling as the clear coat, or at least some obvious gouges and scratches down to the base material (more red color).

EDIT: I'm still not convinced. That aluminum reflective property with scratches is too authentic looking to me. I still say that's machined.

[QUOTE="Rich D, post: 230917, member: 1047"] What, the copper part? Nah, we stared at this picture a few weeks ago. The base copper still looks like plating to me. If it was plastic I'd expect the base copper color to have as much peeling as the clear coat, or at least some obvious gouges and scratches down to the base material (more red color). EDIT: I'm still not convinced. That aluminum reflective property with scratches is too authentic looking to me. I still say that's machined. [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification