Reply to thread

MontgomeryFett, unfortunately, due to the slow deterioration of the molds this is causing some pitting. I've had great results cleaning this section of the rocket lanyard with sanding, primer spray and steel wool alone. No fillers used. The resin is pretty thick on that section of the lanyard so sand away. Hope this helps.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top