Reply to thread

Had to figure out how to keep my ammo rounds from slipping out of my belt. O rings, rubber bands, hot glue weren't working. But with a little bit of engineering... problem solved.


Tightly wrapped electrical tape around the center


[ATTACH=full]209820[/ATTACH]


Then took industrial strength velcro and super glued onto the tape


[ATTACH=full]209821[/ATTACH]



Then took the fuzzy side velcro and super glued them into the ammo holders


[ATTACH=full]209822[/ATTACH]


Inserted the rounds with velcro facing away, twisting the rounds so the velcro catches. Even with the little slivers of velcro in place, anyone knows it's a challenge to pull velcro apart up or down instead of peeling apart. These will stay securely in place.


[ATTACH=full]209823[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top