Reply to thread

Got my 3D printed blaster, then decided to have a backup piece. So I painted the Rubies blaster, filled it with sand to give it a little weight. This will be my primary blaster, the other will just be a display piece. [ATTACH=full]209142[/ATTACH][ATTACH=full]209143[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top