Reply to thread

Here are just a couple pictures from the leather process.  I should also mention that I didn't have any good contact cement for attaching the leather, but I found that using some CA glue worked really quite well. 


After the leather was attached I further weathered it with an umber wash and a bit of sand paper. 


[ATTACH]57129[/ATTACH]


Template for the bottom leather piece. 

[ATTACH]57130[/ATTACH][ATTACH]57131[/ATTACH]


This was after the wash and a bit of weathering. 

[ATTACH]57132[/ATTACH]


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top