Reply to thread

After I fixed what was bothering me about the back section of the helmet, I was able to start on some of the decals.  I don't have a vinyl cutter, so I had to mask of these parts by hand.  I thought this would be very difficult, but with a little patience it came out very nicely.



[ATTACH]57116[/ATTACH]

[ATTACH]57117[/ATTACH]

[ATTACH]57118[/ATTACH][ATTACH]57119[/ATTACH][ATTACH]57122[/ATTACH][ATTACH]57120[/ATTACH][ATTACH]57121[/ATTACH]


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top