Reply to thread

Work has almost ground to a halt the last few days (because of ‘proper work) but finally got the armour fully fitted - still waiting on arrival of another sheet of Sintra (the 1st went ‘missing’) then I can finally do the back and upper abs plate. The soft goods need a light weathering and I have the final blond wookie braid to plait when it arrives. collar studs were printed and gifted me - they will eventually be the correct colours when I fit the back plate and cut the bolts down. I cast some in resin too before I was given these - the printed ones I filled with resin also. Gonna plastic ‘weld’ said bolts to the back plate and have already ‘threaded’ the collar studs - just in case I want to take him apart in the future. Still need to weather the collar and left breast plate but hey ho. The viable wire is the battery lead and switch for the (not screen accurate ha ha) chest lights I made. I may need a re jig that corner to squeeze a frozen Han in there (Head already ordered ha ha). Looking about £100 in materials (excluding the BS lid) so pretty pleased over all. Thinking of making a better cape (better material and colours) too but will see....


edited to add i am repainting the left breast plate and neither the current nor collar plate has been weathered.....


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top