Reply to thread

Progress... need to finish the painting (the collar Paint has cracked but will be sanded pre re coat)  - and make a back plate section - the white flak was just a test run the neck seal is done - material for flak en route. Still lots of work but for a total cost of £80 (plus the black series helmet I already had - which has been weathered a bit) I’m pretty pleased. Not accurate but says ‘Fett’ I feel....[ATTACH=full]206032[/ATTACH][ATTACH=full]206033[/ATTACH][ATTACH=full]206034[/ATTACH][ATTACH=full]206035[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top