Reply to thread

This looks great so far. Enjoying the pics. On that last shot of your dome, you might need to use heavier duty sand paper to cut through the bumps perhaps? Or maybe a flat wood or metal file would help (try it on a non-helmet piece first).

I'll be doing the same at some point (working on armour pieces first).

Keep up the fine work mate


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top