Reply to thread

Message

My first "Well that was stupid moment" - put a load of hot glue on a bit of the left cheek, and then grabbed it to hold it in place, forgetting about the hot glue. Ouch!

Left cheek done, a little messier than I would have liked, but looks kinda ok? Not sure if it's far in enough. Found it quite challenging to get it all squeezed in, but hopefully I can do the right one a little easier, and not burn my fingers off!
[ATTACH]60285[/ATTACH][ATTACH]60286[/ATTACH][ATTACH]60287[/ATTACH]

[ATTACH=full]60285[/ATTACH]

[ATTACH=full]60286[/ATTACH]

[ATTACH=full]60287[/ATTACH]

[QUOTE="Magnavis, post: 416598, member: 8333"] My first "Well that was stupid moment" - put a load of hot glue on a bit of the left cheek, and then grabbed it to hold it in place, forgetting about the hot glue. Ouch! Left cheek done, a little messier than I would have liked, but looks kinda ok? Not sure if it's far in enough. Found it quite challenging to get it all squeezed in, but hopefully I can do the right one a little easier, and not burn my fingers off! [ATTACH]60285.vB[/ATTACH][ATTACH]60286.vB[/ATTACH][ATTACH]60287.vB[/ATTACH] [ATTACH=full]60285[/ATTACH] [ATTACH=full]60286[/ATTACH] [ATTACH=full]60287[/ATTACH] [/QUOTE]

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification