Reply to thread

Message

Have all of the ear parts built. Still doing some minor work on them. Also threw some epoxy on the outside of the bucket. Tacked the visor part back in just for stability. Once this coat cures, I'll resin the bottom, visor area, and fully fiberglass reinforce the inside.

My kid decided he didn't want the keyslots, so that will save me some time and some carpal tunnel. [ATTACH=full]151251[/ATTACH][ATTACH=full]151252[/ATTACH][ATTACH=full]151253[/ATTACH]

Sent from my SM-G930T

[QUOTE="Volktar, post: 452446, member: 9272"] Have all of the ear parts built. Still doing some minor work on them. Also threw some epoxy on the outside of the bucket. Tacked the visor part back in just for stability. Once this coat cures, I'll resin the bottom, visor area, and fully fiberglass reinforce the inside. My kid decided he didn't want the keyslots, so that will save me some time and some carpal tunnel. [ATTACH=full]151251[/ATTACH][ATTACH=full]151252[/ATTACH][ATTACH=full]151253[/ATTACH] Sent from my SM-G930T [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification