Reply to thread

Thanks.

I drew a little circle on a piece of thin cardboard and cut that out with a hobby knife. Punched the three little holes with a belt puncher and repeated the whole thing twice so I ended up with three Bordens. I glued these on top of each other and sanded the edges as smooth and as round as I could with very fine grade sanding paper. The result is what you saw in the pic. Only thing left is to primer it and glue it to the right cheek.

 

easy......:p

 

Peter


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top