Reply to thread

Remember ANOVOS didnt just pop up out of nowhere. they have been making Battlestar Galactica and Star Trek stuff for a little bit now and have been delivering that stuff fine. I also think most of us have seen the warehouse where the TK armor is being made with the piles and piles of armor..so i think its safe to say they will deliver. Preorders are helping them pay for the production. i dont think they are spending the money on fancy cars or anything lol.  That said TK helmets and Fett helmets are very different as the Fett helmets will likely be fiberglass so they cant bang them out as quickly as vac forming. They did a nice job with the the FO TK though, so im thinking this will be a nice bucket.Im sure if they use the highest quality 3D printing method there would be little to no printlines on their master. (have you seen the high detail prints from toolguy through shapeways?..they are near flawless..3D printing has come a long way!)  ...and it may even show up before the EFX...which i honestly really would like to get my hands on also if it comes out before im 65 lol


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top