Reply to thread

absolutely love the imperfections the 3D copier picked up that made it onto the printed version.  i just hope they tuck those LEDs into that topper a bit!  they should be recessed rather than bulging, like Rick's biceps as he flexes on all of us with another stellar paint job.


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top