Reply to thread

So last night I did some more work on on the bucket.

I sanded the filler down and added more to some spots. Re sanded that. I think I have a few more to go before it looks as good as I want it to.

Side note: I used two different types of matt board on this project. The one I am using currently is so much easier to use. It has no paper like substance on the back of it making the cutting out so so so much easier.

I also cut out the cheek sections, the cheek back plate, and formed the cheeks. This is by far the most difficult step that I have had so far. Figuring out how to bend the form appropriately was a nightmare. But I think I finally figured it out. Here are some update pics of what I have.

[ATTACH]39496[/ATTACH][ATTACH]39493[/ATTACH][ATTACH]39495[/ATTACH][ATTACH]39494[/ATTACH][ATTACH]39498[/ATTACH][ATTACH]39497[/ATTACH]


- - - Updated - - -


If anyone reads this thread please any and all criticism or suggestions would be helpful.


[ATTACH=full]39493[/ATTACH]


[ATTACH=full]39494[/ATTACH]


[ATTACH=full]39495[/ATTACH]


[ATTACH=full]39496[/ATTACH]


[ATTACH=full]39497[/ATTACH]


[ATTACH=full]39498[/ATTACH]


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top