Reply to thread

Message

Thanks for the kind words.

I do have one question you guys may have answered previously, but in the pic below, my helmet is resin and is poured somewhat thick where the visor will be going. Is the simplest solution to simply dremel that down in all areas that the visor will go? If dremeling down the needed areas, do you recommend a small grinding/sanding wheel, or would you recommend using a disc cutting wheel to cut out the unwanted pieces? I hope that makes sense, but if not, I'll try to explain better.

Thanks for your help guys as it is very much appreciated.

Take care,
David

[ATTACH]36627[/ATTACH]

[QUOTE="Boogeymanmasks, post: 358626, member: 6281"] Thanks for the kind words. I do have one question you guys may have answered previously, but in the pic below, my helmet is resin and is poured somewhat thick where the visor will be going. Is the simplest solution to simply dremel that down in all areas that the visor will go? If dremeling down the needed areas, do you recommend a small grinding/sanding wheel, or would you recommend using a disc cutting wheel to cut out the unwanted pieces? I hope that makes sense, but if not, I'll try to explain better. Thanks for your help guys as it is very much appreciated. Take care, David [ATTACH]36627.vB[/ATTACH] [/QUOTE]

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification